ACTIVE-RES

ACTIVE-RES

Category:

Resistive wired safety edges

Easy to install and can be shortened to size, ACTIVE-RES is using conductive technology in a small sensitive edge.
The safety device ensures a rapid response to impacts along the entire length of the structure.


 

Control board for resistive edges: equipped with two channels, ensures continuous system self-checking, which is blocked in the case of faults.
Available in protectioncategory 2 PL D (IMQ-certified)


Technical features:
– Operating temperature: -20°C, +55°C
– Degree of protection: IP65

Instruction manual

REQUEST INFORMATION

Related products

  • SW50 fotocellule da incasso intercambiabili con le più diffuse marche sul mercato

    SW50

    Read more
    Pair of built-in photocells The SW50 are built-in photocells with a 20 mt range. Due to the recessed shape and size, the SW50 photocell is interchangeable with the most popular models on the market. Technical features:. Power supply: 12/24 VDC/ac Power consumption: 35 mA Relay capacity: 1A - 24V I.R. wavelength: 950 nm Range: 20 mt Modulation frequency: 1500 Hz Synchronized mode: only when supplied with alternating current Operating temperature: -20°C, +60°C   Datasheet (pdf)   User Manual (pdf)
  • SPK

    SPK

    Read more

    Spiral cable

    SPK spiral cables are made from high-quality materials, making them suitable for the most intensive installations. The extension factor is four times the block length (BL). Spiral cables are resistant to microbes, hydrolysis and almost all mineral oils, thanks to a special sheath compound. In addition, spiral cables are UV-stable and halogen-free. The material is black PUR/PUR, the colour of the wires complies with DIN 47100: 3 wires = brown, white, green 4 wires = brown, white, green, yellow 5 wires = brown, white, green, yellow, grey 6 wires = brown, white, green, yellow, grey, pink Variable cable ends (see table), including 40, 50, 60, 80, 100 or 200 mm without sheath and equipped with cable lugs (AEH). Data sheet  
  • LOW POWER SIGNAL

    LOW POWER SIGNAL

    Read more

    Optics for sensor profile

    Extremely low power consumption Integrated diagnostic system with visual display LED indicator for switching status OSE output signal IP 67, fully protected electronics LOW-POWER-SIGNAL automatically selects the output frequency depending on the connected device: safety signals transmitted to a battery-powered radio link will therefore have a lower frequency than if they were sent directly to the control panel via a spiral cable. This increases battery life and ensures compatibility with most control panels on the market. Technical specifications Power supply 3...27 VCC Maximum door width 1...12 m Output OSE signal Warning lights Yellow LED indicator Connections 3x0,14 mm² Protection degree IP67, electronics encapsulated in epoxy resin Data Sheet
  • L36

    L36

    Read more

    Laser technology sensor for industrial gates and doors

    L36 is an innovative photocell based on time-of-flight (ToF) laser technology, designed for use on gates as a security device. Compared to traditional photocells, it does not require two devices or reflectors. L36 uses a laser rangefinder to measure the distance to an obstacle. The photocell can be used in 3 different modes: Mode A OPERATION AS A PHOTOCELL This mode requires a fixed physical reference point opposite the laser rangefinder. Maximum detection distance: 9 m. The photocell analyses two events. Obstacle detection at shorter distance than the stored distance, during the learning phase. Mode B OPERATION AS A PROXIMITY SENSOR (APPROACH PERPENDICULAR TO THE LASER BEAM) Maximum reading distance 6 m, optimised for detecting movements perpendicular to the beam. The reading distance is programmable and can be adjusted in increments of 0.5 m during programming. Mode C OPERATION AS A SENSOR APPROACHING THE PHOTOCELL FROM ANY DIRECTION Maximum reading distance 6 m, optimised for detecting movements approaching the photocell from any direction. The reading distance is programmable and can be adjusted in increments of 0.5 m during programming. Technical characteristics: Power supply: 12-24V AC/DC Transmission/reception angle: +/- 25° Head rotation angle: 180° Maximum range Mode A: 9 m Modes B and C: 6 m Maximum output load: 30Vdc, 0.5A Operating temperature: -10°C to +60°C Protection class: IP54 Dimensions: 36x123x33 mm Weight: 69 g Data Sheet Instruction Manual
Top